...two-post rack with some cable management is the right choice. But if you have a mix of networking equipment, servers, and patch panels, then a 4-post rack makes more sense because it provides more stable, 4-point mounting for deep equipment. For fle...

...in a rack with Filler Panels. • Cable Managers • Cable management is also an important consideration. Our Horizontal and Vertical Cable Managers help you to route cables along the sides of racks, between racks and to the rackmounted equipment. •  

...modems via RS-232 cable. Many remote access servers also support ISDN with either internal ISDN circuitry or through external terminal adapters. • The remote access server enables remote users to dial into the LAN via a modem connection and us...

...4-pair CAT5/CAT5e/CAT6 cable, leaving the other two pairs free to transmit power for Power over Ethernet (PoE) applications. However, Gigabit Ethernet or 1000BASE-T uses all four pairs of wires, leaving no pairs free for power. So how can PoE work ...

...high-fibre-count ribbon cable. It’s used in high-density fibre applications. • The MU connector • resembles the larger SC connector. It uses a simple push-pull latching connection and is well suited for high-density applications. • Learn more: • Fla...

...means the interconnect cable requires less board space. • Thinner cables • Serial ATA also uses thinner cables (no more than 6.3mm wide) that are available in longer lengths (up to 1 metre) as well as an improved connector design to reduce crosstal...

...Possible causes: • Bad cable or cable that’s too long, causing either the video signals or EDID/HDCP control signals not to be transmitted properly. Make sure that you use quality, high-speed HDMI® cables—they don’t even have to be expensive ones—o...

IP-Based Distribution • IP-Based A/V Distribution • IP-based distribution technologies use transmitters and receivers to extend signals over a TCP/IP network (a LAN or even a WAN, for instance). Oftentimes, they’re called IP streamers when use...

...etc. S/PDIF is based on the professional AES3 interconnect standard. • S/PDIF signals are carried over two types of cables. The first is a 75-ohm coaxial cable with orange RCA connectors. The second is a fiber cable with TOSLINK connectors.